Ada Lavatory Clearance From Wall

From the water closet centerline if the clearance at the water closet is at least 66 instead of 56 deep 604 3 2 ex.

Ada lavatory clearance from wall.

Clearances around toilets and water closets wcs can be measured from the face of the fixture or from its center line and are used to best service the toilet user. Only one bowl in a multi bowl sink needs to offer minimum knee and toe clearances so these multi height lavatory systems combine an ada compliant sink with higher sinks. The minimum knee clearance must be free of equipment or obstructions for a minimum of 8 inches 205 mm extending from the front edge of the lavatory back toward the wall. Accessories such as toilet paper dispensers should be within.

In both alternate stalls the grab bars along the sides of the water closets shall extend at least 54 inches 1370 mm from the back wall and shall have one end no farther than 12 inches 305 mm from the back wall. A compliant lavatory is permitted on the rear wall 18 min. An accessible lavatory at least one in each bathroom must extend at least 17 inches from the back wall and have a clearance of at least 29 inches from the bottom of the sink apron to the finished floor. The lavatory must not be installed at heights greater than 34.

This knee clearance must be 29 inches 735 mm high at the front of the lavatory and no less than 27 inches 685 mm high at a point 8 inches 205 mm back. All other applicable requirements including clearances and turning space must be met. It is recommended that barriers be high enough so that they are not mistaken for a step or other change in level and do not pose a tripping hazard. A minimum height is not specified for barriers demarcating areas with less than 80 of vertical clearance.

The minimum knee clearance must be free of equipment or obstructions for a minimum of 8 inches 205 mm extending from the front edge of the lavatory back toward the wall. Consider solid surface lavatory systems with fully integrated sinks at various heights. Clearances are required at accessible elements fixtures and controls so that people with disabilities including those who use wheelchairs can approach and use them. Minimum clearances between the face of the toilet fixture and the wall or nearest obstruction element are at least 24 61 cm but are recommended to be 36 91 cm.

In both alternate stalls the centerline of the water closet is 18 inches 455 mm from a side wall. The walls behind and surrounding the cabinetry are finished. Clearance reduced at curved or sloped walls recommendation. This knee clearance must be 29 inches 735 mm high at the front of the lavatory and no less than 27 inches 685 mm high at a point 8 inches 205 mm back.

This guide explains requirements in the ada standards for clear floor or ground space and turning space.