Adding Trim To Slab Cabinet Doors

This raised panel design such as is found in shaker style cabinets gives a very traditional look.

Adding trim to slab cabinet doors.

The moulding needs to be mitered trimmed on a 45 degree angle. First trim one tip off your length of moulding at 45 degrees to give you a starting point. One day i was waiting at the paint counter at lowe s there was a bucket of yardsticks and i was thinking that i should buy wood trim that size because it s exactly the look i had in mind flat shaker style and the width of the boards were still small enough for the tiny drawers. Using carved molding and or flat trim to update doors makes for a fairly quick simple and inexpensive update to a flat door.

Set the side pieces in place. Taking a putty knife or finger yes it works fill in all the nail holes and the sides of the cabinet doors where the trim meets against the door plus where the trim pieces meet on the front of the door. Once you have your pieces cut and the edges sanded using your ryobi airstrike nailer nail each trim peace onto the door starting with your two vertical pieces and then your horizontal pieces. As soon as you have all your doors build it s time to get out the wood filler.

Sand the doors lightly to remove any dirt and gloss from the old finish. And bifold doors can quickly and easily be turned into french doors just follow the second half of this tutorial. However flat panel doors otherwise known as slab cabinet doors are increasing in popularity largely because they lend a modern. But looked too thick i would appreciate any info.

To trim the panel measure and cut your trim molding to fit around the panel. Use medium sized decorative trim pieces to create another frame along the inside flat edge of the baseboard pieces. Start by cutting baseboard trim pieces with mitered corners to create a thick frame on the face of your door. Nail in the center first then move to the ends.

We used titebond wood glue for this step. For this you can use a power miter saw or simply a miter box and hand saw. Most cabinet doors still use a form of contoured design in which frames and panels are constructed so that the cabinet faces are dimensional rather than flat. I love what you have done to your cabinets can you tell me what type of trim you used and what the measurements are on the thickness of the trim.

Cut two of the plywood strips to the height of the door and apply wood glue to the backside of each. Adding trim to cabinet doors has obviously been done before. Remove all the hardware from the cabinet doors. Tps header using trim to update doors lots of different styles.

After cutting the pieces to size secure them in place using wood glue and a pin nailer. Adhere the pieces with wood glue and a pin nailer.